This 1.8-inch display breakout is the best way to add a small, colorful and bright display to any project. Since the display uses 4-wire SPI to communicate and has its own pixel-addressable frame buffer, it can be used with every kind of microcontroller. Even a very small one with low memory and few pins available!
The 1.8 display has 128×160 color pixels. Unlike the low cost “Nokia 6610” and similar LCD displays, which are CSTN type and thus have poor color and slow refresh, this display is a true TFT! The TFT driver (ST7735) can display full 18-bit color(262,144 shades) using our library code. This 1.8 inch TFT LCD Color Screen Module SPI Interface has 128 x 160 resolution. it uses the SPI interface to communicate with the controller such as Arduino.
The breakout has the TFT display soldered on (it uses a delicate flex-circuit connector) as well as an ultra-low-dropout 3.3V regulator and a 3/5V level shifter so you can use it with 3.3V or 5V power and logic. This TFT display comes with an onboard sd card slot
This TFT module has an ST7735 driver, adafruit has this library. this library can be downloaded directly from Arduino ide, while using the node MCU you will just have to change the pin configurations in the code.
1 x TFT LCD Display SPI Interface (1.8 inch, 128 x 160, No Touch Screen)
GitHub link of ST7735 driver library for Arduino IDE: ST7735-Library